Replies: 3 (Who?), Viewed: 3798 times.
Quick Reply
Search this Thread
Adka2510
Test Subject
Original Poster
#1 Old 30th Nov 2025 at 1:45 PM
Default change Sea level does not work?? please check photo
Hello,

could somebody please help me with this? Its like i can not sculpt the island and make sea deep. you know what i mean :/ when i click on change sea level , nothing happen actually

Thank you
Screenshots
simsample
Lost in Vilcabamba
retired moderator
#2 Old 30th Nov 2025 at 1:48 PM
To use the change sea level feature, click on the button and then point and click your cursor on the land at the place you want your sea level to be. It might take a few tries to get it exactly where you want it.
Adka2510
Test Subject
Original Poster
#3 Old 30th Nov 2025 at 2:13 PM
Quote: Originally posted by simsample
To use the change sea level feature, click on the button and then point and click your cursor on the land at the place you want your sea level to be. It might take a few tries to get it exactly where you want it.


Thank you. It works but... i used valley steep sculpting, but the green land is still visible under the water. I used large flat map 200, but the whole land square is still visible under water, I cant go any lower when sculpting
Screenshots
simsample
Lost in Vilcabamba
retired moderator
#4 Old 30th Nov 2025 at 5:14 PM
Save your world, then reload it. That should load the sky parameters again to give the correct water fog.
Back to top